Replacing Lamp Module (For Fluorescent Option) - 3DHISTECH Pannoramic 250 FLASH User Manual

Pannoramic 250 FLASH 1.14 SP1 User's Guide

5.3.3 Replacing Lamp Module (for Fluorescent Option)

NOTE: This section recites some extracts from the HXP 120 operating manual. For detailed
information, especially instructions regarding safety, consult that manual. Also, no alignment is
required for the lamp module. Accordingly, the module is fully operational after lamp replacement.
Hot surface! Wait at least twenty minutes to allow the lamp surface to
cool down sufficiently.
1. Disconnect power plug (separate all poles from the mains).
2. Unfix screws of lateral cover plate and remove it from the unit housing (see Figure 74).
3. Press plug securing latches inward (1) then disconnect plug of the lamp module (2) (see
Figure 75).
March 30, 2011
Warning!
Figure 74 – Removing the lateral cover of the HXP 120
Figure 75 – Disconnect plug
3DHISTECH Ltd.
5 Troubleshooting and Maintenance
116(130)