3DHISTECH Pannoramic 250 FLASH User Manual page 117

Pannoramic 250 FLASH 1.14 SP1 User's Guide
4. Loosen pressure bolt with the lever (1) and by keeping the lever pressed, remove lamp
module (2) (see Figure 76).
5. Carefully retrieve the new lamp module from its transporting container. Hold the lamp
module only by its ceramic part.
6. Insert the new lamp module. Make sure that the groove (1) in the contact surface of the
lamp captures the corresponding pin of the lamp mount (see Figure 77).
Incorrect handling may considerably reduce the lamp module's useful
life. Hold it by the ceramic part in all cases! Never touch the lamp's
glass surface or the inside surface of the reflector. Skin oil is harmful to
these parts.
8. Re-establish plug-in connection.
9. Tighten pressure bolt again with the lever.
10. Screw the lateral cover-plate down to the housing.
March 30, 2011
Figure 76 – Removing the lamp module
Figure 77 – Inserting the lamp module
Caution!
3DHISTECH Ltd.
5 Troubleshooting and Maintenance
117(130)