Fuse Replacement - Gilson VERITY 1741 User Manual

Fuse Replacement

CAUTION
Always disconnect the detector from the power source before replacing the line fuse.
1. Using a flat-tip screwdriver release
the fuse holder from its bottom.
2. Take out the fuse holder.
3. Remove the old line fuse.
4. Insert a new line fuse with the
specifications listed
rear panel label. a spare fuse is
included in the accessory package
supplied with the detector.
5. Insert the fuse holder back into the
receptacle.
on the
VERITY® 1741 UV-VIS DETEcToR | USER'S GUIDE 29