Table of Contents
Advertisement
Door Installation
To prevent damage during shipping, the detector is shipped with the door removed. Slip the
door on the hinges in the open position (see pictures below).
Waste Tubing Assembly Installation
The detector is equipped with a waste channel, directing the liquid away from the detector. The
supplied waste tubing assembly includes silicone tubing and the necessary connectors.
Figure 11
Waste Tubing Assembly Installation
1. Remove the Y connector from the silicone tubing (1).
2. connect the silicone tubing to the L connector (2)
3. connect the L connector to the detector (3)
4. Place the end of the tubing in a waste container.
Make sure the waste container is placed at a location that is lower than the detector for proper
drainage.
NOTE
Waste tubing from other system components can be connected using the Y connector removed in
step 1 and part 4 and cutting another small piece of silicone tubing if desired.
VERITY® 1741 UV-VIS DETEcToR
| USER'S GUIDE
15
Advertisement
Table of Contents
