Table of Contents
Advertisement
IN thIS Chapter:
|
● Troubleshooting
● Repair and Return Policies
Troubleshooting
PROBLEM
After switching the detector on, no
LED on the front panel is lit
Noisy or drifting baseline
Warning or error message
Leaking flow cell
chapter 5
trOUBLeShOOtING
Chapter 5 |
31
|
32
CAUSED BY / CONDITIONS
Line fuse failure.
Electronics failure.
Leaking or dirty flow cell, bubbles,
or non-transparent mobile phase.
Electronics/optic failure.
Clogged tubing.
Damaged or worn flow cell.
SOLUTION
Check the main fuse on the
rear of the detector see
Fuse Replacement on page 29.
Contact your local Gilson
representative.
Check cell connections. Check
mobile phase. Check cell purity.
Contact your local Gilson
representative.
Try resetting of error and if is not
-
successful contact your local Gilson
representative.
Check and replace flow cell inlet/
outlet tubing, if necessary.
Replace the flow cell.
VERITY® 1741 UV-VIS DETEcToR
| USER'S GUIDE
31
Advertisement
Table of Contents
