Io Config - Gilson VERITY 1741 User Manual

Uv-vis detector
Table of Contents

Advertisement

Neg. Range
The negative dynamic range setting influences the range of absorbance measuring. This is a
theoretical value. The range varies depending on lighting conditions when the signal is reset
(autozero), and the range is different for each wavelength. In practice, it is necessary to reset
the signal (autozero) on the non-absorbing liquid at a given wavelength to reach the maximum
negative range.
Setting of Negative Dynamic Range
Setting
Description
NORMAL
−0.1 AU (default value)
MEDIUM
-0.3 AU
HIGHER
−0.7 AU

IO Config

The VERITY 1741 Detector has an interface for connection to external devices. The interface has
two universal inputs (DIn1 and DIn2) and two universal outputs (DoUT1 and DoUT2).
Interface
PIN
ABBR.
NAME
1
+5V
-
2
DIN1
DIGITAL INPUT 1
3
DIN2
DIGITAL INPUT 2
4
DOUT1
DIGITAL OUTPUT 1
5
DOUT2
DIGITAL OUTPUT 2
6
GND
GROUND
For external input/output interface, connector blocks are used (included in accessories).
To connect a cable to the connector block, loosen the nut using a small flat-tip screwdriver.
Remove approximately 3 to 4 mm of isolation from the connected cable. Insert the skinned part
of cable into the place under the nut and tighten the nut. Gently pull on the cable to ensure the
conductor holds in the block. If the conductor is too thin, it is better to remove isolation from a
longer section and bend the skinned part before inserting in the block.
INTERFACE SPECIFICATION
DESCRIPTION
Auxiliary supply +5V DC, maximum output current 50mA.
Digital input 1. Compatible with TTL, HC, HCT. Overvoltage
category up to 24 V. Opened at level H. Active at level L.
Digital input 2. Compatible with TTL, HC, HCT. Overvoltage
category up to 24 V. Opened at level H. Active at level L.
Digital output 1. Compatible with TTL, HC, HCT. Maximum
output current 24mA. Output resistance 75ohm.
Digital output 2. Compatible with TTL, HC, HCT. Maximum
output current 24mA. Output resistance 75ohm.
Ground. Internally connected with chassis.
FRonT PAnEl conTRol
| USER'S GUIDE
45

Advertisement

Table of Contents
loading

Table of Contents