Unpacking - Gilson VERITY 1741 User Manual

Leak Sensor
The leak sensor contains a reference and a measuring sensor. If the measuring sensor is
immersed in liquid, then the sensor generates a signal. Processing of this signal is handled in
TRILUTIoN Lc, or via front panel control. For more information about front panel control, refer
to Appendix B | Front Panel Control on page 37.
If a leakage occurs, it is first necessary to eliminate the leakage, and then dry the area of the
liquid drain and the measuring sensor.

Unpacking

The detector is delivered with most of the major components already assembled. Retain all
packing material so the detector may be shipped safely in the future. Store the installed test cell
after removal as it is used when testing the lamp.
Standard Equipment
● VERITY 1741 Detector with test cell (installed)
● Screwdriver (for loosening the lamp cover and lamp holder)
● open End Wrench (for loosening the lamp)
● Power cord
● Fuse
● Ethernet cable (1 m)
● Terminal Block connector (6-pin)
● Waste Tubing Assembly
● Analog output cable (1 m)
● Removable Door
● VERITY® 1741 UV-VIS Detector Documentation USB that includes
○ User's Guide
○ Installation Qualification (IQ)
○ Declaration of conformity
○ china RoHS Declaration Table
○ TRILUTIoN® Lc Software for VERITY® 1741 UV-VIS Detector Instructions
Required Accessory
FLOW CeLL
A flow cell is a required item, but is ordered separately, depending on your
application. Inlet/outlet tubing and fittings are supplied with each flow cell. Refer to
Appendix A | Parts and Accessories on page 33 for part numbers.
Optional Accessory
SheLF
An optional stacking shelf that was designed for use with the VERITY 1741 Detector is ordered
separately (part number 21040255). It allows for stacking a pump on top of the detector.
8
INTRoDUcTIoN
|
VERITY® 1741 UV-VIS DETEcToR