Use Of Cameras; Power On Equipment; Power Off; Led Status - Foxtech SurePulse VS User Manual

Insert the camera COMM cable into the camera, as shown.
The camera supply voltage is 6 V~30 V, Considering that the power supply
cable has a certain voltage drop, it is recommended that the minimum voltage
should not be less than 7V, and the maximum voltage should not be higher
than 30V, and ensure that the polarity is correct. Failure to follow this
rule will permanently cause damage to the camera and DLS module, and is not
covered by warranty. Please refer to the "6.2 Electrical Interface
section" for wire order definition.
2.2 Use of camera

2.2.1 Power on equipment

When the external power is connected,the camera is powered on.
When the camera is powered on, the camera status light and the
DLS status light are white and always on. After the initialization
is completed, it starts to flash according to the working state.
Please refer to the relevant information of "2.2.3 LED status
"section for specific status definition.
2.2.2 Power Off Equipment
Turn off the external power directly after the work is completed,
the camera will be powered off.

2.2.3 LED status

LED display status corresponds to the different working status
and fault information of the camera, which can be used as a judgment
before flight, as shown in the following table:
MS600V2 Universal Multi-Spectral
Camera User's Manual
Warning
5