Foxtech Seeker-30 Max Manual
  1. Manuals
  2. Brands
  3. Foxtech Manuals
  4. Digital Camera
  5. Seeker-30 TIR
  6. Manual

Foxtech Seeker-30 Max Manual

30x optical zoom camera with 3-axis gimbal
Hide thumbs Also See for Seeker-30 Max:

Advertisement

Table of Contents

See also: User Manual
SEEKER-30 Max 30X
Optical Zoom Camera
with 3-Axis Gimbal

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Seeker-30 Max and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Foxtech Seeker-30 Max

Summary of Contents for Foxtech Seeker-30 Max

  • Page 1 SEEKER-30 Max 30X Optical Zoom Camera with 3-Axis Gimbal...

  • Page 2: Disclaimer And Warning

    Civil Aviation Administration of China (CAAC). FOXTECH is not responsible for damage, injury or any legal liability caused by the direct and indirect use of this product. Users should follow all safety guidelines including but not limited to this article.
  • Page 3 It adopts advanced 3-axis stabilization, which can keep the camera steady under any states, like high speed and intense shaking status. SEEKER-30 Max can be applied in many fields: to check the Power line tower from long distance, target tracking, emergency monitoring and rescue etc.
  • Page 4 Middle Down 1. Camera 8. Connecting Stick 2. Motor for Pitch Axis 9. Lower Damping Plate 3. Motor for Roll Axis 10. Damper 4. Motor for Yaw Axis 11. SD Card Slot 5. Control Box 12 Micro-hdmi Interface 6. Power Interface 13.
  • Page 5 Unit: mm...

  • Page 6: Installation

    1. Preparation 1.1 Supported installed device types The Seeker-30 MAX gimbal needs to be used with HD image transmission system (1080P). 1.2 Supported SD Card Types The gimbal camera SD card supports up to 128GB. Please use an SD card of Class10 or UHS-1 and above to ensure normal video recording.

  • Page 8: Operation

    Operation: It is recommended to use the SBUS to control the gimbal, please insert the SBUS device into the A channel when use it.
  • Page 9 Note 1. If the Seeker-30 Max is directly powered off while recording, an error will be reported after the gimbal is restarted. As shown in Figure 1. Solution: Press the reset button on the bottom of the gimbal.

  • Page 10: Specification

    4. Seeker-30 MAX is precision equipment. Do not add light shield, payload and other items, otherwise it will cause serious consequences such as poor performance of the gimbal and even burning. 5. Please keep the lens clean and wipe it with a clean glasses cloth. The dirty lens may cause the slow focus speed or even can’t focus etc.

Table of Contents