When The Alarm Time Is Reached - Silvercrest SIUR 10 A1 Operating Instructions Manual

GB

When the alarm time is reached

140
♦ Use the i /i control points
on the remote control to select the hour for the required alarm time. Next, touch
the control point
♦ The alarm time minute display will now blink. Use the i /i
points / on the device or the i /i
control to select the minute for the required alarm time. Next, touch the
control point
AL OUT
♦ will now appear on the display, and you can select the required
alarm function or deactivate the alarm setting. Use the i /i
points / on the device or the i /i
control to select the required alarm function:
iPort play:
♦ Touch the control point
control to complete the setting.
NOTE
► If approx. 15 seconds passes without any changes taking place during
setting, the device cancels the alarm setting.
In the case of the "iPort play" setting, the device connected to the iPort will
be started for 60 minutes with increasing volume.
In the case of the "Signal tone" setting, a signal tone will be sounded with
increasing volume. The duration of the signal is limited to 10 minutes.
In the case of the "Radio" setting, the radio will be switched on. The previously
selected station will be activated for a maximum of 60 minutes at an increasing
volume.
♦ Touch the SNOOZE control point
The alarm number will blink for this period. A renewed alarm will sound
after 10 minutes.
NOTE
► The repeat alarm function is possible up to 60 minutes after the set wake
time is reached.
♦ Press any button to stop the current alarm, even if the key lock is switched on.
/ on the device or the i /i
or press the i key
keys
or press the i key
keys
Signal tone: Radio:
or press the i
to stop the alarm for 10 minutes.
keys
on the remote control.
control
/ on the remote
on the remote control.
control
/ on the remote
Deactivated:
key on the remote
SIUR 10 A1
/