Setting The Clock; Radio Reception; Setting The Alarm Time; Switching The Alarm Function On - Silvercrest KH 2189 Operating Instructions Manual

Assembly
Before operating the device, make sure that it is in
a faultless condition. If it is not, it may not be used.
• Insert the plug into a power socket. Select a
power socket that is at all times easily accessible,
so that the plug can be quickly withdrawn in the
event of a malfunction.

Setting the clock

When you take the device into use for the first
time after inserting a new battery:
Whilst pressing and holding the button
• Repeatedly press, or press and hold, the button
HOUR
t
to set the hours.
HOUR
• Release the t
hour indicator is shown in the display
• Repeatedly press, or press and hold, the button
MIN.
y
to set the minutes.
MIN.
y
• Release the
red minute indicator is shown in the display
The programmed time setting is automatically accepted
TIME
as soon as the button

Radio Reception

• Place the slider switch
• Turn the volume regulator
• Select the radio frequency range by using the
waveband selector
• Now select the desired radio station by turning
TUNING
the regulator
TIME
r
button as soon as the required
s
.
button as soon as the requi-
r
is released.
ON
h
at the position
j to a midway position.
FM/AM
f
.
g
.
Note:
To improve reception in the FM frequency range,
slowly move and hold the end of the wire aerial
in various directions. When you have found the
best reception for the desired transmitter, fix the
wire aerial into this position e.g. with adhesive
tape. For the reception of AM transmitters, an aerial
is built into the device. For improved reception,
alter the position of the device in radio mode.

Setting the alarm time

When the correct time has been programmed in as
: described above, proceed as follows:
Whilst holding the button
• Repeatedly press, or press and hold, the button
HOUR
t
• Release the
hour indicator is shown in the display
• Repeatedly press, or press and hold, the button
MIN.
y
to set the minutes.
s
. • Release the
red minute indicator is shown in the display
The programmed alarm setting is automatically
accepted as soon as the button
released.

Switching the alarm function on

.
If the clock and alarm time are set correctly, as
described above:
• Place the slider switch
The alarm is now switched on. Serving as a check,
a dot appears in the left of the display
You will be woken by the radio if ...
• the volume regulator
level at which you will be woken.
You will be woken by the alarm tone if...
• the volume regulator
position OFF/BUZZ.
- 5 -
AL. ON
o
to set the hours.
HOUR
t
button as soon as the required
MIN.
y
button as soon as the requi-
h in the position
j
is placed at a sound
is engaged at the
j
e
pressed down:
s
.
s
.
AL. ON
o
is
AUTO
.
s
.