Ie Activating The Alarm Function - Silvercrest SRW 2 A1 Operating Instructions Manual

Programming alarm times and alarm type
When programming the alarm times, you can select whether an
alarm tone should sound at the programmed time or whether the
radio should start playing. Two different alarm times (Alarm 1/Alarm 2)
can be programmed. Radio mode must be deactivated.
♦ Press the AL1/DOWN button
flashes on the display
or right next to the alarm type "Alarm" (
♦ Press or hold the HR/− button
♦ Press or hold the MIN/+ button
♦ If you wish to set the alarm type "Radio" (
DOWN button
on the lower left or right of the display next to the alarm type
"Radio" (
♦ Wait until the time display and the dot next to the alarm type stop
flashing to accept the setting.
NOTE
► If you want to be woken by the radio, you will also need to
select the desired station and volume as well as the alarm time.
Activating the alarm function
♦ Press the AL1/DOWN button
the display
alarm function is now activated.
SRW 2 A1
and a point appears on the lower left
or AL2/UP button
15
).
a point appears to the lower left and/or right. The
or AL2/UP button
15
).
to set the hours.
11
to set the minutes.
12
), press the AL1/
again. A point appears
14
or AL2/UP button
15
. The time
14
briefly. In
14
17
GB
IE
CY