Alarm Function; Setting The Alarm Time - Silvercrest SCUR 3 A1 Operating Instructions And Safety Instructions

♦ Once the programmed sequence has played completely through, CD play-
back stops and "MEMORY" appears again on the display
II/SCAN/AMS button
again.
NOTE
► To delete a programmed sequence of tracks, press the ■ ST/MONO
button
switch the device into standby mode.
► During CD playback, or while playback is paused, you can jump to another
programmed track by pressing the −VOL+/ І◄◄ TUNE ►►І dial
briefly and then turning it to the left or right.

Alarm function

The device has two alarms: "AL 1" and "AL 2". You can programme an alarm
sound or playback of the last selected radio station or a CD at a certain time.
NOTE
► If no setting is made within 10 seconds while in setting mode, the setting
process is cancelled and the device exits the settings menu.

Setting the alarm time

♦ The device must be standby mode. Press the
longer than 2 seconds to switch off the device, if necessary.
♦ Press the ALARM button
flashes on the display
♦ Use the −VOL+/ І◄◄ TUNE ►►І dial
functions "AL 1" and "AL 2".
♦ Press the ALARM button
on the display.
♦ Turn the −VOL+/ І◄◄ TUNE ►►І dial
Then press the ALARM button
flash.
♦ Turn the −VOL+/ І◄◄ TUNE ►►І dial
minutes. Then press the ALARM button
for the alarm mode appear on the display
alarm mode flashes.
♦ Turn the −VOL+/ І◄◄ TUNE ►►І dial
desired alarm mode:
–
–
–
GB │ MT
■ 46
│
again to play back the programmed sequence
twice during CD playback or use the
for longer than 2 seconds until "AL 1" or "AL 2"
.
to confirm the selection. The hour "0" flashes
Alarm with alarm tone
Alarm with CD player
Alarm with radio
/SOURCE button
/SOURCE button
to choose between the alarm
to the left or right to set the hours.
to save the setting. The minutes ":00"
to the left or right to set the
to save the setting. The symbols
and the symbol for the active
to the left or right to select the
. Press the ►/
to
once
for
SCUR 3 A1