Setting The Reminder Function - Silvercrest SIUR 10 A1 Operating Instructions Manual

♦ Use the i /i
on the remote control to set the day for the current date.
♦ Touch the
control to change to setting the month. Use the i /i
on the device or the i /i
month for the current date.
♦ Touch the Set|OK control point
on the remote control again to save the current setting and to change to the
next menu item.
NOTE
► The date will be reset to 01.06.2013 if the device is disconnected from the
mains power and no battery has been inserted, or if the battery is too weak.

Setting the reminder function

You can set up to 6 dates on which an automatic reminder will be triggered. The
SDA (SDA=Special Day Alert) function is useful as a reminder, for example for
a specifi c date or for birthdays or other repeating events.
Precondition: The device is in clock/standby operating mode.
♦ Touch the Set|OK control point
on the remote control three times. In the display
be shown. Touch the Set|OK control point
Set OK key
memory slots
♦ Then touch the
remote control, in order to enter the required date and required alarm time
using the i /i
i
specifi c year, you will then be programming a single-instance alarm. If you
select
♦ After this, press the i
on the remote control, in order to switch the blinking
therefore to activate the alarm.
♦ Proceed as above to program the remaining memory slots.
♦ Touch the Set|OK control point
on the remote control again to save the current setting and to change to the
next menu item.
SIUR 10 A1
control points
control point
on the remote control again in order to select the required
SDA2 SDA6
to
control point
control points
keys / or i keys
ALL
instead of a year, the device will remind you of the date every year.
control point
/ on the device or the i /i
or press the i
keys / on the remote control to set the
on the device or press the Set OK key
on the device or press the Set OK key
, the
on the device or press the
.
or press the i
/ or control point
on the remote control). If you select a
on the device or press the i key
on the device or press the Set OK key
keys /
key on the remote
control points /
SDA1
wording will
key on the
(or the i /
OFF ON
over to and
GB
133