Override Rotary Switch; Quick Stop Module - Bosch Rexroth VAM 10.2 Project Planning Manual

DOK-SUPPL*-VAM*XX.2***-PR03-EN-P
Rexroth IndraControl VAM 10.2/40.2 Machine Control Panels
7.2.4

Override rotary switch

7.2.5

Quick stop module

Fig. 7-6: Override rotary switch
Feed override
Spindle override
Tab. 7-3: Override rotary switch
The module is connected to the logic circuit board via the internal shift regis‐
ter bus. The switch positions of the both rotary switches are transmitted to the
master control via Profibus DP.
The configuration and address assignment are described in
ter 9 "Commissioning" on page
Only the VAM 40.2 machine control panel features a quick stop
module.
The machine buttons can be wired application-specifically.
Bosch Rexroth AG
16 switch positions from "0" to "Max"
16 switch positions from "Min" to "Max"
47.
33/69
Module design
chap‐