Status Display "System Stop - Bosch Rexroth VAM 10.2 Project Planning Manual

DOK-SUPPL*-VAM*XX.2***-PR03-EN-P
Rexroth IndraControl VAM 10.2/40.2 Machine Control Panels
9.4.2

Status display "system stop"

Pos LED Display Significance
H1 "UL" 24 V supply (X10 plug)
Green 24 V supply present
Green~ The bus connection is kept in the initialization phase by
one or several
Modules
Green~~
System stop (see
stop"" on page
Off
No 24 V supply present
H2 "DIA" Diagnostic display
Red One or several modules report diagnostics.
Red~ System stop
Red~~ System stop (see
stop"" on page
No diagnostics or system stop
Off
H3 "RUN" Operating display
Green Cyclic I/O data exchange (normal operation)
Green~ Configuration error (command/actual assignment differ‐
ent)
Off
The bus connection is not triggered by the Profibus DP
master.
Causes:
●
●
●
●
●
H4 "BF" Bus error
Red The bus connection is searching for the baud rate
Red~ Parameterization error (invalid parameterization data)
Off The bus connection detected and applied the baud rate
Green or red Static display
~ Slow flashing of the display (0.8 s on/0.2 s off)
~~ Fast flashing of the display (0.125 s on/0.125 s off)
Tab. 9-1: Status displays
The two LEDs "H1 UL" and "H2 DIA" display the "system stop" state. During
system stop, the outputs are set to the safe state (0) and the bus traffic to the
Profibus DP master is canceled. The system stop can only be quit by a re‐
start of the component ('Network on').
Bosch Rexroth AG
chapter 9.4.2 "Status display "system
49)
chapter 9.4.2 "Status display "system
49)
Incorrect Profibus DP station address
The Profibus DP station address is assigned sever‐
al times at the bus
The trigger watchdog time is expired
Error in master parameter set (GSD file); e.g. incor‐
rect PNO-ID number, incorrect buffer sizes (Prm,
Cfg, ...)
Incorrect parameterization in User_Prm_Data[1]
49/69
Commissioning