Table of Contents
Advertisement
Troubleshooting and tips
8.7
System will not boot
The system will not boot after installing a new hard disk drive.
SAS configuration incorrect
Ê Check the settings for the hard disk drives (SAS Device Configuration) and
the additional settings in the SAS configuration menu.
8.8
Incorrect date and time
Ê Set the date and time in the operating system or in the BIOS Setup under
the Main menu, using System Date and System Time respectively.
I
Note that the operating system may affect the system time. For example,
the operating system time may deviate from the system time under
Linux, and would overwrite the system time in the default setting on
shutdown.
If the date and time are still wrong after the server has been switched off and
back on again, replace the lithium battery (for a description refer to the
"FUJITSU Server PRIMERGY TX2560 M1 / RX2560 M1 Upgrade and
Maintenance Manual") or contact our customer service team.
8.9
Hard disk drive error messages at system
boot
Various hard disk drive error messages may occur when the system is
rebooted. These error messages are caused by modifications in the selected
RAID configuration.
RAID controller configuration incorrect
Ê Check and correct the settings for the drives using the RAID controller
configuration program.
I
Further information is provided in the "Integrated RAID for SAS User's
Guide" (on the Fujitsu manuals server under x86 Servers - Expansion Cards
- Storage Adapters - LSI RAID / SCSI Controllers) or in the "Modular RAID
90
Operating Manual
TX2560 M1 / RX2560 M1
Advertisement
Table of Contents
