GRAPHTEC GL840 User Manual page 149

[Wired LAN settings]
(1) Set the IP address automatic acquisition to "Off".
(2) Set the IP address etc. as follows:
• IP address: 192.168.0.1
• Subnet mask: 255.255.255.0
• Port number: 8023
• Gateway: 0.0.0.0
• DNS address: 0.0.0.0
• Non-communication disconnection: Off
After setting, apply the settings.
(3) Then, make the GLT400 settings. Set the mode switch of GLT400 to "Remote" and then turn on the power
of GLT400.
(4) Connect between the GLT400 and the PC with a USB cable and install "GLT400 Setting App" which is the
setting software of GLT400. Use the GLT400 Setting App to set the following:
• IP address: 192.168.0.2
• Subnet mask: 255.255.255.0
• Port number: 8023
• Gateway: 0.0.0.0
• DNS address: 0.0.0.0
< Example of GLT400 Setting App setting >
For the settings of GLT400 and GLT400 Setting App, refer to the GLT400 User's Manual.
(5) Search for the sensors which connected in "Remote unit settings".
• Connection I/F: Wired LAN
• Connection remote unit: Remote terminal
• Connection: Set RT1 to On
After setting the above, search for RT1.
If GLT400 is found, the unit names that can be connected are displayed. If the remote terminal list is not
displayed, repeat until you find it.
* If the list is not displayed, check the settings.
CHAPTER 3 Settings and Measurement
3-73