Installing The Wireless Unit (B-568: Option) - GRAPHTEC GL840 User Manual

CHAPTER 2 Checks and Preparation

2.9 Installing the Wireless Unit (B-568: Option)

To connect the GL840 to the wireless LAN, insert the wireless unit in the SD CARD slot.
This section describes the installation procedure using the wireless LAN unit (B-568).
•
When the SD CARD has been inserted into the SD CARD slot, please remove the SD CARD.
•
When the wireless unit has been inserted, the SD CARD cannot be inserted into the SD CARD slot.
•
When inserting the wireless unit, please make sure that the power is turned OFF and then install the unit.
•
When using the wireless LAN, please check the "3. Notes on Radio Law" in the "Notes on Use" described
above.
How to insert the wireless LAN unit
Insert the wireless LAN unit into the SD CARD slot.
Wireless LAN unit
(Option: B-568)
(1) Turn OFF the GL840's power.
(2) Remove the SD CARD protective cover.
* Please keep so as not to lose the SD CARD protective cover.
(3) When the SD CARD has been inserted, remove the SD CARD.
* The SD CARD is unlocked by pushing gently the SD CARD. Then, remove the SD CARD.
2-16
Protective cover
SD CARD