Connecting To A Pc - GRAPHTEC GL840 User Manual

CHAPTER 2 Checks and Preparation

2.10 Connecting to a PC

Use the USB or LAN Interface to connect the GL840 to a PC.
Connection Using a USB Cable
(1) The GL840 complies with the EMC Directive in the state when the supplied ferrite core is attached to the
USB cable.
To connect to the PC with the USB cable, attach the supplied ferrite core to the USB cable as shown in
the following figure.
USB cable
(2) Connect between the GL840 and PC with the USB cable.
The USB connector is adjacent to the LAN connector. Make sure the cable is inserted into the correct
connector.
If the USB cable is used, the USB driver must be installed in your PC. Please refer to "USB Driver
Installation Manual" in the supplied CD-ROM for the installation procedure.
•
Use the cable with A and B connectors to connect the GL840 to a PC.
A connector
2-18
Lock part Ferrite core (Supplied item)
USB cable
B connector