Connecting The Co2 Sensor (Gs-Co2) (Optional) - GRAPHTEC GL840 User Manual

2.22 Connecting the CO2 Sensor (GS-CO2) (Optional)

For the specifications of CO2 sensor, refer to the Instruction Manual supplied with the sensor.
The connecting procedure between the GL840 and CO2 sensor is described.
• Turn Off the GL840's power.
• Connect firmly the CO2 sensor's connector to the GL840's GS sensor and terminal / adapter connection
terminal (GS-INPUT).
• Turn On the GL840's power and make sure that the sensor settings are displayed on the AMP Setting
screen.
1. Hook portion ...................Used to mount to a wall.
2. Internal sensor ...............A sensor that detects the CO2 is built in.
3. Connector .......................Used to connect to the connector on the GL840 main module.
•
Please do not use in a state in which only the CO2 sensor is attached on a wall or the like.
The damage of the connected cable and connector or the drop of the GL840 may be caused.
•
Do not use the module close to your face.
Your breath may affect measurements.
•
Blocking the module's ventilation hole may cause the airflow to affect measurements.
1. Hook portion
2. Internal sensor
3. Connector
GL840 main module
The lamp for detecting flashes every two seconds.
CHAPTER 2 Checks and Preparation
2-45