Setpoint; Reverse - Siemens SINAMICS IOP-2 Operating Instructions Manual

Control menu

7.1 Setpoint

7.1 Setpoint
Setting the Setpoint
The setpoint value determines the speed at which the motor runs as a percentage of its full
range of motion.
To change the setpoint, the following actions should be performed:
Select Control
Note
Setpoint in Hertz (Hz) for SINAMICS CU230P-2
The setpoint screen by default displays the motor speed as a percentage of the total possible
speed of the motor.
This behaviour changes for the SINAMICS CU230P-2 where the default setpoint value is
displayed in Hertz (Hz).
7.2

Reverse

Setting Reverse
The function of the reverse command is to set the direction of rotation of the motor from its
normal forward motion.
To reverse the direction of the motor, the following actions should be performed:
Select Control
40
Select Setpoint
Select Reverse
Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
Use Touch-wheel to set the
Setpoint
Select Off or On
Intelligent Operating Panel 2 (IOP-2)