Startup In Hand Mode - Siemens SINAMICS IOP-2 Operating Instructions Manual

Select Control Parameter
Select the input that will
receive command signal
Select the input to receive the
setpoint signal
Once the setpoint signal input has been selected, the IOP-2 will return to the Setpoint
selection screen then press ESC for >3 secs, to return to the status screen.
In this example, the converter is now setup to receive the ON/OFF1 command from Digital
Input 0 (DI0) and the speed setpoint from Analog Input 0 (AI0), from the controlling PLC.
7.5

Startup in Hand mode

Overview
Startup in Hand mode allows the converter, under the control of the Intelligent Operator
Panel (IOP-2), to startup in Hand mode automatically. The command source is then taken
from the off and on buttons of the IOP-2.
An example of setting up the Startup in Hand mode is given in the instructions below.
Intelligent Operating Panel 2 (IOP-2)
Operating Instructions, 06/2020, FW V2.6, A5E39549448B AH
Select required function
Select Setpoint Parameter
Control menu
7.5 Startup in Hand mode
Select source of command
signal
Select the setpoint signal
source
43