Table of Contents
Advertisement
Operation | Automax 100 | Extension module TS-AC E2-M3-1X
Bus coupler navigation „Configuration"
Via the navigation point „Configuration" it is possible to adapt the bus coupler to the own
requirements.
See the following figure
Web based management interface „Configuration"
Under „Ethernet-Port" you will find information about port 1 (X1) and (X2). Furthermore, it is
possible to set „Autonegation" or „Manual Crossover" for both Port 1 and Port 2. NOTICE. A
password must be entered in order to accept the values! The password at factory setting is:
private
IP address, subnet mask and default gateway can be configured under „IP Settings".
NOTICE. To accept the values, it is necessary to enter a password! The password at factory
setting is: private
Under „Process Data Watchdog Timeout" can:
The process data watchdog timeout can be set between 200 ms and 65 000 ms. A Value
of 0 switches off the process data watchdog. NOTICE. To accept the values, it is
necessary to enter a password! The password for the factory setting is: private
A detected network error with activated process data watchdog can be quit. NOTICE. To
quit detected network errors, the input of a password is required! The password at factory
setting is: private
Under „Startup Behaviour" can:
The plug-and-play mode can be enabled/disabled. NOTICE. A password must be
entered to accept the change of the plug-and-play mode! The password at factory setting
is: private
After changing the bus configuration (e.g. by exchanging a module), quit the possibly
adapted parameterization. NOTICE. To quit the adjusted parameterization, the input of a
password is required! The password at factory setting is: private
Bus coupler navigation „Administration"
Various settings functions can be executed via the navigation point „Administration".
See the following figure
Web based management interface „Administration"
Bosch Rexroth AG | 05.2021 | DOK-SUPPL*-TS-AC E2-M3-ITRS-EN-P
67/94
Advertisement
Table of Contents
