Local Diagnostics And Status Indicators - Bosch rexroth Automax 100 Operating Instructions Manual

Local diagnostics and status indicators

Des. Color Meaning
U Green U
L Logics
NET Green/ Network status
yellow/
red
CO Yellow/ Configuration
red
PP Yellow Plug-and-play
mode
RDY Green/ Ready
yellow/
red
About this product | Automax 100 | Extension module TS-AC E2-M3-1X
Local diagnostics and status indicators
Local diagnostics and status indicators
Status Description
On Feed-in of logics voltage available.
Off Feed-in of logics voltage not available.
Green ON At least one connection to device established.
Green, Connection to device can be established.
flashing
Yellow ON IP configuration (IP address) is invalid (0.0.0.0).
Yellow, BootP requests or DHCP requests/discover are sent.
flashing
Red ON Network error, the process data watchdog was set active, the substitute
value behavior of outputs is executed.
Red, flashing IP address conflict at static configuration via rotary coding switch (IP address
assigned twice).
Off Device not ready for operation.
Yellow ON Parameterization of I/O modules has failed.
Red ON Current configuration of local bus does not correspond to saved one.
Off Current configuration of local bus does correspond to saved one.
On Plug-and-play mode activated.
Off Plug-and-play mode deactivated.
Green ON Device ready for operation.
Green/yellow, Undervoltage or overvoltage of logics supply
flashing
Overtemperature
Yellow ON Firmware/bus coupler booting
Yellow, Firmware update is performed.
flashing
Bosch Rexroth AG | 05.2021 | DOK-SUPPL*-TS-AC E2-M3-ITRS-EN-P
27/94