Bosch rexroth Automax 100 Operating Instructions Manual page 46

40/94 About this product | Automax 100 | Extension module TS-AC E2-M3-1X
Bosch Rexroth AG | 05.2021 | DOK-SUPPL*-TS-AC E2-M3-ITRS-EN-P
The following figures illustrate the electrical connection at the example of a pressure sensor.
Before use, connections „I1+" to „I4+" must be parameterized according to the required
current signal (0 mA ... 20 mA, 4 mA ... 20 mA or -20 mA ... 20 mA).
Parameterization can be carried out via the IoT Gateway software.
Sensor connection. M12 connector
Front view on pins
System connector. M12 socket Front
view on socket
Assignment of the analog input „I1+" at system connector „-5XG1"
Sensor connection. M12 connector Front
view on pins
System connector. M12 socket Front
view on socket
Assignment of the analog input „I2+" at system connector „-5XG2"
Connector plug of the S20-AI-4-I
module (-5KE1)
Connector plug of the S20-AI-4-I
module (-5KE1)