Bosch rexroth Automax 100 Operating Instructions Manual page 57

Assembly | Automax 100 | Extension module TS-AC E2-M3-1X
1 Step 1
2 Step 2
3 Step 3
Assembly of extension module TS-AC E2-M3-1X
Step 1
Loosen the two knurled screws at the basic module. Rotate the knurled screw in counter-
clockwise direction until the guide bore is free, see 
Step 2
Plug the extension module on the basic module. For connection, ensure that the guide pins
are not jammed inside the guide bores. Attach the extension module with the two knurled
screws.
For better handling, the recessed grip on the rear of the extension module should be used.
Step 3
Pull the three safety plugs out of their parking position.
Step 4
Plug the three safety plugs according to their colors (red, blue, green) into the 3 dedicated
safety sockets of the basic module.
If the cable length is too short, there is remaining length inside the housing. Carefully pull
the remaining cable length out of the housing.
Assembly is completed.
4 Step 4
5 Guide bore is free
6 Guide bore is blocked
Bosch Rexroth AG | 05.2021 | DOK-SUPPL*-TS-AC E2-M3-ITRS-EN-P
51/94