Required Tools And Materials - Siemens RUGGEDCOM RSG920P Installation Manual

RS-232 Console Port
POWER LED
ALARM LED
Port Status LEDs
Access Plate
Digital Inputs
Failsafe Alarm Relay
Power Supply Terminal Block
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RSG920P:
RUGGEDCOM RPS1300 or equivalent 54 VDC
output power supply
AC or DC power cord (16 AWG)
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #8-32 screws
RUGGEDCOM RSG920P
Installation Manual, 04/2021, C79000-G8976-1172-07
The serial console port is for interfacing directly with the device
and accessing initial management functions. For information
about connecting to the device via the serial console port, refer to
"Connecting to the Device (Page
Illuminates when power is being supplied to the device.
Green
Red
Off
Illuminates when an alarm condition exists.
Indicate the status of each port. For more information, refer to
"Communication Ports (Page
The removable access plate provides access to the USB Type-B
console port and microSD slot.
• Use the USB console port to connect directly to the USB port
on a workstation. For more information about the USB console
port, refer to
• Use a microSD card to load/store the firmware and
configuration for the device. For information about using a
microSD card, refer to
(Page
Two isolated independent digital inputs to monitor external
equipment, such as a passive switch or voltage provided by external
equipment. For more information, refer to
Inputs (Page
Latches to default state when a power disruption or other alarm
condition occurs. For more information, refer to:
• "Connecting the Failsafe Alarm Relay (Page 15)"
• "Failsafe Alarm Relay Specifications (Page 33)"
A pluggable terminal block. For more information, refer to:
• "Connecting Power (Page 17)"
• "Power Supply Specifications (Page 33)"
Tools/Materials
1.3 Required Tools and Materials
23)".
Color
Device ready
Device booting up
No power
27)".
"Connecting to the Device (Page
"Inserting/Removing the MicroSD Card
25)".
16)".
For supplying PoE power to the device.
For connecting power to the device.
For connecting the device to the network.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Introduction
Description
23)".
"Connecting the Digital
Purpose
3