Appendix: Safety And Application Notes; General; Application As Directed; Transport, Storage - Danfoss AHF 005 Operating Instructions Manual

AHF 005/010 Operating Instructions

6 Appendix: Safety and Application Notes

6 Appendix: Safety and Application Notes

6.1.1 General

During operation, filter module units may have, according to their type of protection, live, bare, in some cases also movable or rotating parts as well as
hot surfaces.
Non - authorized removal of required cover, inappropriate use, incorrect installation or operation, creates the risk of severe injury to persons or damage
to material assets.
Further information can be obtained from the documentation.
All operations concerning transport, installation and commissioning as well as maintenance must be carried out by qualified, skilled personnel (IEC 364
and CENELEC HD 384 or DIN VDE 0100 and IEC-Report 664 or DIN VDE 0110 and national regulations for the preventions of accidents must be observed).
6
According to this basic safety information qualified skilled personnel are persons who are familiar with the erection, assembly, commissioning and operation
of the product and who have the qualifications necessary for their occupation .

6.1.2 Application as directed

Filter modules are components, which are designed for installation in electrical systems or machinery.
When installing in machines, commissioning of the filter modules (i.e. the starting of operation as directed) is prohibited until it is proven, that the machine
corresponds to the regulations of the EC Directive 83/392/EEC (Machinery Directive); EN 60204 must be observed.
Commissioning (i.e. starting operation as directed) is only allowed when there is compliance with the EMC-Directive 89/336/EEC.
The filter modules meet the requirements of the Low-Voltage Directive 73/23/EEC. The technical data and information on the connection conditions must
be obtained from the nameplate and the documentation and must be observed in all cases.

6.1.3 Transport, Storage

Notes on transport, storage and appropriate handling must be observed.
The filter modules have to be protected from inadmissible stress. In particular; during transport and handling: Components are not allowed to be bent.
Distance between isolation must not be altered. The units are equipped with electrostatic sensitive devices, which may be damaged by improper handling.
Therefore it has to be avoided to get in contact with electronic components. If electronic components are damaged mechanically the unit must not be
put into operation, as it cannot be ensured, that all relevant standards are observed. Climatic conditions must be observed according to prEN 50178.

6.1.4 Installation

The devices must be erected and cooled according to the regulations of the corresponding documentation.
The filter modules must be protected from inappropriate loads. In particular; during transport and handling: Components are not allowed to be bent.
Distance between isolation must not be altered. Touching of electronic components and contacts must be avoided.
Filter modules contain electro-static sensitive components, which can be easily damaged by inappropriate handling. Electrical components must not be
damaged or destroyed mechanically (health risks are possible!).
6.1.5 Electrical Installation
When working on live filter modules, the valid national regulations for the prevention of accidents (e.g. VBG 4) must be observed. Before any installation
or connection works, the plant has to be switched off and to be secured properly.
29
®
MG.80.C1.02 - VLT is a registered Danfoss trademark