Table of Contents
Advertisement
Clamp and mills by means of the collet chuck and the corresponding collets.
Clamp end face mills by means of shell end mill arbors.
When drilling make sure that
the suitable speed is set depending on the diameter of the drill,
the pressure must only be such that the drill can cut without load
in case of too strong pressure the drill will get worn early or even might break resp. get
jammed in the hole. If the drill gets jammed immediately stop the main motor by pressing
the emergency stop button,
for hard materials, e.g. steel, use commercial cooling / lubricating agents,
generally always drive the turning spindle out of the workpiece.
ATTENTION!
Do not use the quick action drill chuck for milling tools. Never clamp a milling cutter into
the quick action drill chuck. Use a collet chuck and the corresponding collets for the end
mill.
When milling make sure that
the corresponding cutting speed is selected,
for workpieces with normal strength values, e.g. steel 18-22 m/min,
for workpieces with high strength values 10-14 m/min,
the pressure is selected in a way that the cutting speed remains constant,
for hard materials commercial cooling / lubricating agents are used.
1.5
Possible dangers caused by the milling-machine
The milling-machine was built using the latest technological advances.
Nonetheless there remains a residual risk, since the milling-machine operates with
at high speeds,
with rotating parts and tools,
with electrical voltages and currents.
We have used construction resources and safety techniques to minimize the health risk to per-
sonnel resulting from these hazards.
If the milling-machine is used and maintained by the personnel who are not duly qualified,
there may be a risk resulting from incorrect or unsuitable maintenance of the milling-machine.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
be duly qualified,
strictly follow these operating instructions.
Always disconnect the milling-machine from the electrical power supply when performing clean-
ing or maintenance works.
WARNING !
The milling-machine may only be used with functional safety devices.
Disconnect the milling-machine immediately, whenever you detect a failure in the safety
devices or when they are not fitted!
All additional devices installed by the operator have to be equipped with the prescribed
safety devices.
This is your responsibility being the operating company!
Safety devices on page 13
GB
MT50
10
Translation of original operating manual
Version 1.2.8 - 2020-08-03
Advertisement
Table of Contents
