16.13
Adjusting the headlight range
16.14
Diagnostics connector
16.15
Accessories circuit 1 and accessories circuit 2 front
»
If the boundary between light and dark does not meet
specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Turn adjusting wheel
Info
Turn counterclockwise to increase the headlight range;
turn clockwise to reduce the headlight range.
If you have a payload, you may have to correct the
headlight range.
F00892-10
–
Set the headlight to marking
Guideline
The light-dark boundary must lie exactly on lower mark-
B
ing
when the motorcycle is ready to operate with the
rider mounted along with any luggage and a passenger if
applicable.
400726-11
The diagnostics connector
(SUPER ADVENTURE S CN)
A diagnostic adapter for connection to a cross-manufacturer
diagnostic interface has been connected at the factory.
Info
Unplug the diagnostics adapter to use the KTM diag-
nostics tool.
Following completion of the diagnosis, plug the diag-
nostics adapter back in.
E02236-10
Installation location
–
Accessories circuit 1
front are located behind the right mask spoiler.
E02300-10
ELECTRICAL SYSTEM 16
p. 147)
p. 146)
1
to adjust the headlight range.
B
.
1
is at the rear part of the vehicle.
1
and accessories circuit 2
2
at the
147