Checking The Rear Hub Damping Rubber Pieces - KTM 1290 SUPER ADVENTURE S 2021 Owner's Manual

15 WHEELS, TIRES
15.5
132
E02266-12

Checking the rear hub damping rubber pieces

Info
The engine power is transmitted from the rear sprocket to the rear wheel via the 6 damping rubber pieces.
The damping rubber pieces wear out during operation. If the damping rubber pieces are not changed in
time, the rear sprocket carrier and the rear hub will be damaged.
V00777-10
V00778-10
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
Finishing work
–
Check the chain tension. (
–
Remove the vehicle from the center stand. (
Preparatory work
–
Raise the vehicle with the center stand. (
–
Remove the rear wheel.
Main work
–
Check the damping rubber pieces
age and wear.
» If the damping rubber pieces of the rear hub are damaged
or worn:
–
Change all the damping rubber pieces of the rear
hub.
–
Lay the rear wheel on a workbench with the rear sprocket fac-
ing upward and insert the wheel spindle in the hub.
–
Check the rear sprocket play
Info
Measure the play on the outside of the rear sprocket.
Play of damping rubber
pieces on rear wheel
»
A
If clearance is larger than the specified value:
–
Change all the damping rubber pieces of the rear
hub.
Finishing work
–
Install the rear wheel.
–
Check the chain tension. (
–
Remove the vehicle from the center stand. (
6
in the hole.
7
.
M6 10 Nm (7.4 lbf ft)
p. 99)
p. 96)
p. 96)
( p. 129)
1
of the rear hub for dam-
A
.
≤ 5 mm (≤ 0.2 in)
( p. 130)
p. 99)
p. 96)