Removing Front Fender; Installing Front Fender; Cleaning The Dust Boots Of The Fork Legs - KTM 1290 SUPER ADVENTURE S 2021 Owner's Manual

13.34

Removing front fender

13.35

Installing front fender

13.36

Cleaning the dust boots of the fork legs

–
Open holder
–
Remove screws
–
Take the fender off to the front.
Info
Pay attention to the brake lines and the cable.
E02253-11
–
Position the fender.
Info
Pay attention to the routing of the brake lines and the
cable.
–
Mount and tighten screws
Guideline
Screw, fender
E02253-10
–
Insert the brake lines and cable in brackets
holder.
Preparatory work
–
Raise the vehicle with the center stand. (
–
Remove front fender. (
Main work
–
Push dust boots
Info
The dust boots remove dust and coarse dirt particles
from the inside fork tubes. Over time, dirt can accumu-
late behind the dust boots. If this dirt is not removed,
the oil seals behind can start to leak.
E02251-10
Warning
Danger of accidents Oil or grease on the brake discs
reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when nec-
essary.
–
Clean and oil the dust boots and inner fork tubes of both fork
legs.
SERVICE WORK ON THE CHASSIS 13
1
and detach the brake lines and cable.
2
.
1
.
M5x12
p. 117)
1
of both fork legs downward.
3.5 Nm
(2.58 lbf ft)
2
and close the
p. 96)
117