Avaya 8800 Series Installation Manual page 31

Caution:
Risk of equipment damage
To avoid contamination, optical ports must only be cleaned when there is evidence of
contamination or reduced performance, or during their initial installation.
To prevent oil contamination of connectors, use only high-quality canned compressed air.
Do not allow the air extension tube to touch the bottom of the optical port.
Procedure steps
1. Remove dust or debris by blowing canned air into the optical port of the device using
2. Clean the optical port by inserting a wand moistened with alcohol into the receptacle
3. Dry the optical port by inserting a dry wand into the receptacle and rotating it.
4. Remove lint by blowing compressed air into the optical port.
5. Reconnect the optical connector and check for proper function.
Installation — SFP, SFP+, XFP, and OADM Hardware Components
the canned air extension tube.
and rotating it.
Each cleaning wand must only be used to clean one optical port.
Important:
Do not let the IPA evaporate; wipe it dry immediately. Alcohols can leave a
residue that is difficult to remove.
If you are not reinstalling the connector, be sure to use a protective cap.
If problems persist, ensure that the connector or receptacle is free from damage.
Care of fiber optic equipment
August 2013 31