Attaching The Brackets To The Switch - Enterasys I Series Hardware Installation Manual

Mounting the Switch
To install the rack-mount kit and then install the switch into the rack:
1. Place the switch on a sturdy flat surface.
2. At the back of the switch, locate and remove the two DIN mounting screws as shown circled
in
time.
3. Locate and remove the two side screws and top screw in each corner as shown in
Save the screws.
4. Install one of the brackets provided in the rack-mount kit to the back of the switch using the
screws you removed in Step 3.
5. Repeat the previous steps to install the other bracket to the other side.
Figure 2-6
1 Rack-mount brackets
6. If you are installing the I3H-PWR external AC to DC power supply, refer to
External Power Supply to the Rack Mount
7. Using the mounting hardware provided, attach the front of the brackets to the rack as shown
in
2-12 Installation
Figure 2-6. Retain the screws in case you want to mount the switch on a DIN rail at a later

Attaching the Brackets to the Switch

2 Rack-mount screws
Figure 2-7 on page 2-13. Tighten securely.
3 DIN screws (4 need to be removed from chassis)
Bracket" on page 2-13, then return to
Figure 2-6.
"Attaching the
Step 7 below.