Enterasys I Series Hardware Installation Manual page 8

Application of Council Directive(s): 2004/108/EC
European Representative Name: Enterasys Networks Limited
European Representative Address: Nexus House, Newbury Business Park
Conformance to Directive(s)/Product Standards: EC Directive 2004/108/EC
Equipment Type/Environment: Industrial Ethernet Switch and Interface Modules for use in
Council Directive 94/9/EC, EN60079-0:06 and EN60079-15:05 This equipment has been evaluated and marked as Ex nC IIC T4
equipment under DEMKO, Lyskaer 8, P.O. Box 514, 2730 Herlev, Denmark, Certificate No. 07 ATEX 0706436X. Each device is
marked II 3G and is suitable for use in Zone 2 explosive atmospheres. Device must be installed in a minimum IP54 and
Pollution Degree 2 enclosure as defined in IEC 60529 and EN 60529. Power source must comply with SELV requirements as
defined in the Low Voltage Directive 2006/95/EC and 93/68/EEC and not exceed the rated input by more than 40%.
Enterasys Networks, Inc. declares that the equipment packaged with this notice conforms to the above directives.
vi
Declaration of Conformity
Manufacturer's Name: Enterasys Networks, Inc.
Manufacturer's Address: 50 Minuteman Road
2006/95/EC
Andover, MA 01810
USA
London Road, Newbury
Berkshire RG14 2PZ, England
EN55022:2006
EN 55024:1998
A1:2001
A2:2003
EN 61000-3-2:2006
EN 61000-3-3:1995
A1:2001
A2:2005
EC Directive 2006/95/EC
EN 60950-1:2006
A11:2009
A1:2010
EN 60825-1:2007
EN 60825-2:2004
A1:2007
EC Directive 94/9/EC
EN 60079-0:2006
EN 60079-15:2005
Certificate No.: 07 ATEX 0706436X
Zone 2 Explosive Atmospheres, Commercial or Light
Industrial Environments..