Table of Contents
Advertisement
Mounting the Switch
4.
If installing the DIN clip to the back of the switch, you must install both DIN clips. Refer to
Figure 2-14
a.
b. Determine how the clips need to attach to the back of the switch. It is recommended that
c.
d. Attach the other DIN clip using the remaining four screws.
Figure 2-14
1 DIN clip
5.
Refer to
the rail itself. If attaching to a horizontal DIN rail, make sure that the base rail clip is on top.
6.
Secure the latch to the clip, making sure that the notches in the latch attach to the other rail.
7.
Tighten the captive screw.
8.
Make sure that the switch is securely fastened to the rail.
2-18 Installation
on page 2-18 and perform the following:
Locate the 4 screws in the back of the switch at each side, as shown in
remove the screws. Save the screws.
the base rail clips attach to the top of a horizontally-mounted DIN rail, but they can attach
to the left or right side of a vertically-mounted DIN rail.
Attach one DIN clip using four screws.
Installing DIN Clips to the Back of the Switch
Figure 2-15
on page 2-19 and hook the notches on the base rail clip onto one side of
2 Screws
Figure
2-14, and
Advertisement
Chapters
Table of Contents
