Mounting; Rack Mounting; Figure 3-2. Attaching The Brackets - Enterasys Matrix-V V2H124-24 Hardware Installation Manual

Mounting

This switch can be mounted in a standard 19-inch equipment rack or on a desktop or
shelf. Mounting instructions for each type of site follow.
Installing Optional Modules: Before mounting the switch, you may want to install
optional modules. If you have purchased optional slide-in 100BASE-FX,
1000BASE-T, 1000BASE-T/SFP, or stacking modules, install these modules now,
following the instructions "Installing an Optional Module into the Switch" on page 3-5.

Rack Mounting

Before rack mounting the switch, pay particular attention to the following factors:
• Temperature: Since the temperature within a rack assembly may be higher than
the ambient room temperature, check that the rack-environment temperature is
within the specified operating temperature range. (See page C-1.)
• Mechanical Loading: Do not place any equipment on top of a rack-mounted unit.
• Circuit Overloading: Be sure that the supply circuit to the rack assembly is not
overloaded.
• Grounding: Rack-mounted equipment should be properly grounded. Particular
attention should be given to supply connections other than direct connections to
the mains.
To rack-mount devices:
1. Attach the brackets to the device using the screws provided in the Bracket
Mounting Kit.

Figure 3-2. Attaching the Brackets

3
Mounting
3-3