Table of Contents
Advertisement
Rack Mounting the Switch
Attaching Brackets and Installing in Rack
Proceed as follows to install the switch into a 19‐inch rack:
1.
Attach the rackmount brackets to the switch, as shown in Figure
M3 x 6 mm flathead screws shipped with the switch.
Figure 3-5
Á
1 Rackmount brackets
2.
With the mounting brackets attached, position the switch between the vertical frame
members of the 19‐inch rack as shown in Figure
to the frame using four mounting screws (user supplied).
Figure 3-6
1 Rails of 19-inch rack
3.
If you are installing this switch in a stacked configuration, repeat this procedure for
each switch until all switches have been installed in the stack, then proceed to
"Connecting High‐Speed Stacking Cables" on page 3‐11. Otherwise, proceed to
"Connecting AC and RPS Power" on page 3‐15.
3-10 Hardware Installation
Attaching the Rackmount Brackets
À
Fastening the Switch to the Rack
Á
À
2 M3 x 6 mm flathead screws
3‐6. Then fasten the switch securely
Á
À
2 Mounting screws (supplied by user)
3‐5, using the eight
À
Á
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the SecureStack C2 C2G124-24 and is the answer not in the manual?
Questions and answers