The View Administrative Option - Avaya one-X 1603SW Administrator's Manual

Administering Telephone Options
Status is 100Mbps HDX when PHY2STAT = 4
●
Status is 100Mbps FDX when PHY2STAT = 5
●
5. To change the PHY2 value, press *.
Depending on the current value, the next sequential valid PHY2 value is selected and
displayed as the status. For example, if the current value is 10Mbps HDX (2), pressing *
changes the value to 3 (10Mbps FDX).
The following text displays left-justified at the top of the display:
Save new value?
*=no
6. Press the * button to terminate the procedure, or the # button to save the new values.
If you press the # button, the following text displays.
New value
being saved
The new values are saved and a restart occurs automatically. The user interface is restored
to its previous state.

The View Administrative Option

If you are using static addressing and encounter problems, use the following procedure to verify
the current values of system parameters and file versions.
Note:
Unless otherwise prevented using administration, the user can view but not
Note:
change most of the parameters associated with Local Administrative Procedures.
For more information about this option, see the applicable user guide(s).
Note:
If the View Network Information option is not available due to being disabled by
Note:
administration, use the ADDR option to view IP addresses. See
Addressing Installation
incorrectly. Verify whether you were provided with correct IP addresses.
102 Avaya 1603SW-I SIP Deskphones Administrator Guide
#=yes
on page 105. The IP addresses might have been entered
Static