Avaya one-X 1603SW Administrator's Manual page 40

Avaya Aura Communication Manager Administration
Table 7: CM/SIP Configuration Requirements (continued)
Task/Form
Continue adding station
information for the SIP
phone using the Station
form (page 2)
Continue adding station
button assignments for
the SIP telephone using
the Station form (page 4)
40 Avaya 1603SW-I SIP Deskphones Administrator Guide
Command
add station xxxxxx
(where xxxxxx
represents the
extension number)
Field(s) Value(s)
Bridged Call Set to "y" if the extension for
Alerting this SIP telephone will have a
"bridged" appearance defined
on another non-SIP
telephone. Note that no other
attributes of the bridged
appearance feature apply to
SIP telephones (e.g. off-hook
indication, bridge-on, etc.).
Restrict Last By default, the last call
Appearance appearance is reserved for
outgoing calls from a phone.
On stations with only three (3)
call appearances, set the field
to "n" for proper SIP
conference and transfer
operation. In this mode, all
call appearances are
available for making or
receiving calls.
AUDIX Name Enter the name of the voice
messaging system
administered for this system.
Coverage After This field, with a default of "s"
Forwarding for system, governs whether
an unanswered forwarded
call is given CM coverage
treatment.
Per Station CPN If CM is configured to always
Send Calling send Caller ID, you can
Number? individually block certain
stations by setting this field to
"n". This field also needs to
be set to "n" if you want to
use the "Calling Number
nblock" FNE.
BUTTON Fill in the number of call
ASSIGNMENTS appearances ("call-appr"
buttons) to be supported for
1. call-appr
this telephone. Use the
2. call-appr
following guidelines to
etc.
determine the correct
number:
To support certain transfer
and conference scenarios,
the minimum number of
"call-appr" buttons should be
3.
4 of 5