Avaya one-X 1603SW Administrator's Manual page 92

Administering Telephone Options
will not forward frames received with the 802.1AB LLDP group multicast address as the
●
destination MAC address between the Ethernet line interface and the secondary Ethernet
interface.
A 1603SW-I SIP IP Deskphone initiates LLDP after receiving an LLDPDU message from an
appropriate system. Once initiated, the telephones send an LLDPDU every 30 seconds with the
following contents:
Table 13: LLDPDU Transmitted by the 1603SW-I SIP IP Deskphones
Category
Basic Mandatory
Basic Mandatory
Basic Mandatory
Basic Optional
Basic Optional
Basic Optional
IEEE 802.3
Organization
Specific
TIA LLDP MED
TIA LLDP MED
92 Avaya 1603SW-I SIP Deskphones Administrator Guide
TLV Name (Type)
Chassis ID
Port ID
Time-To-Live
System Name
System Capabilities
Management Address
MAC / PHY
Configuration / Status
LLDP-MED
Capabilities
Extended
Power-Via-MDI
TLV Info String (Value)
IPv4 IP Address of telephone.
MAC address of the telephone.
120 seconds.
The Host Name sent to the DHCP server in
DHCP option 12.
Bit 2 (Bridge) will be set in the System
Capabilities if the telephone has an internal
Ethernet switch. If Bit 2 is set in Enabled
Capabilities then the secondary port is
enabled.
Bit 5 (Telephone) will be set in the System
Capabilities. If Bit 5 is set in the Enabled
Capabilities than the telephone is registered.
Mgmt IPv4 IP Address of telephone.
Interface number subtype = 3 (system port).
Interface number = 1.
OID = SNMP MIB-II sysObjectID of the
telephone.
Reports autonegotiation status and speed of
the uplink port on the telephone.
Media Endpoint Discovery - Class III - IP
Telephone.
Power Value = 0 if the deskphone is not
currently powered via PoE, else the
maximum power usage of the deskphone
plus
all modules and adjuncts powered by the
telephone in tenths of a watt.
1 of 2