Avaya one-X 1603SW Administrator's Manual page 75

Table 11: 1603SW-I SIP IP Deskphones Customizeable System Parameters (continued)
Parameter Name
DHCPSTD
DIALPLAN
DNSSRVR
DOMAIN
DOT1X
DOT1XSTAT
DSCPAUD
DSCPSIG
DSTOFFSET
Administering Options for the 1603SW-I SIP IP Deskphones
Default Description and Value Range
Value
0 DHCP Standard lease violation flag. Indicates whether to
keep the IP Address if there is no response to lease
renewal. If set to "1" (No) the telephone strictly follows
the DHCP standard with respect to giving up IP
Addresses when the DHCP lease expires. If set to "0"
(Yes) the telephone continues using the IP Address until
it detects reset or a conflict (see
" " (Null) Dial plan for operation with a secondary controller. The
DIALPLAN parameter is used to determine one or more
valid dialstrings. Valid value is 0 to 1023 characters that
define the dial plan. See
Telephones
0.0.0.0 Text string containing the IP Address of zero or more
DNS servers, in dotted-decimal format, separated by
commas with no intervening spaces (0-255 ASCII
characters, including commas).
" " (Null) Text string containing the domain name to be used when
DNS names in system values are resolved into IP
Addresses. Valid values are 0-255 ASCII characters.
0 Defines the telephone's operational mode for IEEE
802.1X.Valid values are:
0 = Unicast Supplicant operation only, with PAE multicast
pass-through, but without proxy Logoff.
1= Unicast Supplicant operation only, with PAE multicast
pass-through and proxy Logoff.
2= Unicast or multicast Supplicant operation, without
PAE multicast pass-through or proxy Logoff.
0 IEEE 802.1X status. Enables/disables IEEE 802.1X
function and, if enabled, additionally defines reaction on
received multicast or unicast EAPOL messages. Valid
values are:
0 = Supplicant operation disabled.
1 = Supplicant operation enabled, but responds only to
received unicast EAPOL messages.
2 = Supplicant operation enabled, responds to received
unicast and multicast EAPOL messages.
46 Differentiated Services Code Point for audio. Values
range from 0 to 63.
34 Differentiated Services Code Point for signaling. Values
range from 0 to 63.
1 Used for daylight saving time calculation in hours. Values
range from 0 to 2.
DHCP Generic
Setting the Dial Plan on SIP IP
for more information.
Setup).
2 of 10
Issue 1 June 2010 75