Switching On The Device; Display Buttons - Lauda P 10 Operation Manual

5.5

Switching on the device

Fig. 28: Home window
5.6

Display buttons

66 / 130
WARNING!
Risk of contact with cold/warm parts if the operator does not
realize that the device is switched on
Scalding, cold burns
The remote control unit must be kept within visual range of

the device.
1. Switch on the device at the mains switch.
A signal tone is emitted and the operation and fault indicator LED

lights up several times.
The LED then lights up green continuously when there are no
faults pending.
2. The version numbers of the installed software appear on the display for
about 5 seconds.
Then the home window appears.
3. The device can now be operated using the Base remote control unit.
Fig. 29: Base remote control unit
1 Display
2 Four cursor buttons
3 Input button
4 Right softkey (standby)
5 Left softkey (display/ESC)
6 Brightness sensor
PRO bath thermostats and circulation thermostats
You can now view the version numbers of the software
installed on the device in the menu at any time.
V04REV14