Database Service Properties Up To Logiqworks 1.3; General - GE LOGIQworks Basic Service Manual

GE M S
EDICAL YSTEMS
D 5184024-100, R
IRECTION
3-5-5-7 Transmit (cont'd)
Retry Interval (sec.): Specifies the (minimum) waiting time before a transmission (that failed on a
•
previous attempt) can be tried again.
Thread Priority: Priority of the transmission thread within the Connection Service. Changing this
•
setting may influence system performance.
Allow use of Remote Access Service (RAS): This option is used to specify whether Remote
•
Access Service (RAS) can be used for teleradiology destinations. If enabled, RAS is available when
configuring teleradiology destinations. If disabled, the RAS parameters for a destination cannot be
accessed or used.
This setting is typically set during the installation of a system, and should not be changed at a later
stage without great care. Especially when changing the option from disabled to enabled, please
make sure RAS is actually installed on the system. Also make sure the RAS service dependency
is enabled for the Connection Service.
3-5-6

Database Service Properties up to LOGIQworks 1.3

WARNING
WARNING ONLY CHANGE THE DEFAULT SETTINGS IF YOU ARE AN EXPERT!
3-5-6-1

General

To set up the general aspects of the Database Service:
1.) Select Configuration > Database Service... from the Data Selector menu.
2.) Select the General tab from the Database Service Properties page.
Figure 3-134 Database Service Properties - General (Default Settings)
ROOT Directory: Click the Browse... button to locate the root directory of the Database Service.
•
This is the directory where the DATABASE.EXE file is located.
Work Directory: Click the Browse... button to specify a working directory to hold the temporary files
•
generated by the database application.
5
EVISION
Chapter 3 Installation
LOGIQ ® B S
WORKS ASIC ERVICE
Administrator only
Administrator only
M
ANUAL
3-159