AT&T Merlin II User Manual page 25

2-14 Changing the Current Settings
To change any of these Call Processing Options:
Dial the MERLIN II Attendant extension number from a Touch-Tone
1
phone, preferably a single-line set.
you are programming from a multiline Touch-Tone phone
NOTE: If
connected to a MERLIN II system control unit, you must enter an
additional pound ( # ) sign each time a pound ( # ) sign appears in
a programming command.
Wait for an answer.
2
Dial * followed immediately by your authorized caller number and #.
3
The two-beep combination tone sounds.
Dial * followed by "Program Code" shown on Table 2-3.
4
Dial the number you have entered under "Current Setting".
5
Dial #.
6
The two-beep confirmation tone sounds.
Commands 9709 and 9710 require an additional # to enter.
NOTE:
Continue programming or exit authorized caller mode by dialing * #.
7
To disconnect, dial #.
8
=
2 9 0 1 Day Answer Delay
=
2 9 0 2 Night Answer Delay
=
2 9 0 3 Dialing Delay
=
2 9 0 4 Extension Delay
=
2 9 1 6 Extension Digits
= Extension Transfer
2 9 1 8
=
Lowest Extension
9 7 0 9
=
9 7 1 0 Highest Extension