AT&T Merlin II User Manual page 22

Dial * 8 followed immediately by the route number (O through 9).
4
Dial the extension code:
5
Dial the transfer code:
6
Dial the extension number where the caller will be connected.
7
The extension number for route O should be 720 or an extension
NOTE:
number that is not in your dial plan. This allows calls transferred
to the receptionist to appear on a line button and not on the
receptionist's intercom button.
Dial ##.
8
The two-beep confirmation tone sounds.
Continue programming or exit authorized caller mode by dialing *#.
9
To disconnect, dial #.
10
Programming a New Route for Supervised Transfer
To program a supervised transfer, refer to Planning Form F and follow the
steps below:
Dial the MERLIN II Attendant extension number from a Touch-Tone
1
phone, preferably a single-line set.
If you are programming from a multiline Touch-Tone phone
NOTE:
connected to a MERLIN 11 system control unit, you must enter an
additional pound ( # ) sign each time a pound ( # ) sign appears in
a programming command.
Wait for an answer.
2
Dial * followed immediately by your authorized caller code and #.
3
The two-beep confirmation tone sounds.
Dial * 3 followed by a route number (O through 9 ) and the Day Primary
4
Extension number.
The extension number for route O should be 720 or an extension
NOTE:
number that is not in your dial plan. This allows calls transferred
to the receptionist to appear on a line button and not on the
receptionist's intercom button.
Dial #.
5
Dial the Day Secondary Extension number.
6
Dial #.
7
Dial the Night Secondary Extension number.
8
9 Dial #.
The two-beep confirmation tone sounds.
11 = Day Primary Extension
21 = Night Primary Extension
=
2 Blind Transfer
=
5 Disconnect
.
Changing the Current Settings 2-11