GE LOGIQ S6 Service Manual page 54

GE H
EALTHCARE
D 5162630, R
IRECTION EVISION
Section 3-2 Receiving and Unpacking the Equipment
NOTE: Check the shipping container for special instructions. Verify that the container is intact. In some
cases a secondary container may be used. If so, ask the carrier for unpacking instructions.
For the protection of LCD monitor, re-use the packing sleeve whenever possible, in case of shipment
NOTICE
after unpacking.
Turn over the LCD monitor, and
place the sleeve to the location
above. Make sure LCD arm is
locked.
3-4
3
Pull over the sleeve to the LCD arm, and
secure the LCD Sleeve with adhesive
tape after placing it to the proper
location.
Figure 3-6 Labels on Package
Section 3-1 - Overview
LOGIQ™ S6 S
(cont'd)
Secure the LCD Sleeve with adhesive tape after
placing it to the proper location.
Adhesive Tape (Each side)
Front view after packed
Rear view after packed
Note: These labels are attached onto the
shipping box, defining environment at
which consoles are to be transported or
stored.
M
ERVICE ANUAL