GE LOGIC C2 Series Technical Publication page 121

Mains on applied part (continued)
WARNING
NOTE:
Ultrasound System
Direction 5444964-100 English Rev. 5
A typical test setup for TEE probes could be as indicated below:
Figure 4-6. TEE probe leakage isolation (sink) current test
The handle of the TEE probes must not be immersed.
For immersion levels, please refer to the User Manual.
Where applicable, a typical test setup of non-TEE Probes can
be as illustrated in: Figure 4-4 on page 4-36.
The test passes when the reading measure less than the values
in:
• Table 4-8 on page 4-21.
–
Common Service Information
Electrical safety tests
4-43