GE Vivid T8 Basic Service Manual page 270

Care and Maintenance
Leakage current limits (continued)
Table 10-14: Type CF Applied Part Leakage Current Limits - ECG Connections
Country
All
NOTE:
10-22
Normal Open
Condition Ground
0.1 mA 0.5 mA
*Mains Applied refers to the sink leakage test where mains
(supply) voltage is applied to the part to determine the amount of
current that will pass (or sink) to ground if a patient contacted
mains voltage.
The following tests are performed at the factory and should be
performed at the site. These tests are: chassis leakage current,
and probe leakage current. All measurements are made with an
electrical safety analyzer which should be calibrated and
compliant with AAMI/ESI 1993 or IEC 60601 or AS/NZS 3551.
Table 10-15:
Applied Parts or accessories that contact the patient to
Parts perform their function. For ultrasound equipment,
(AP) this includes transducers and ECG leads.
Type BF Body Floating or
non-conductive ultrasound
probes which are marked
with the 'man in box' BF
symbol. this includes all
transducers.
Type CF Cardiac Floating or
non-conductive
intraoperative probes for
direct cardiac contact and
isolated ECG connections
so marked with the 'heart in
box' CF symbol.
Sink The current resulting from the application of mains
Leakage voltage to the applied part. This test is required
test for Type CF applied parts.
Reverse
Polarity
0.5 mA
Equipment Type and Test Definitions
Vivid T8/ Vivid T8 Pro – Basic Service Manual
5490863-100 English Rev. 03
Open *Mains
Neutral Applied
0.5 mA 5.0 mA